Phone (805)543-1662    

CCM2500F

Tool List:

     -Floor Jack

     -Jack Stands

     -Assorted Metric Tools

     -GM Torsion Bar Tool or Two Armed Gear Puller

Lift Instructions Front

1. Park the truck on level ground and measure the height of the fender lip
2. Jack up the front of the truck and support the frame with jack stands
3. With an 18mm socket remove the torsion bar adjusting bolt
4. Using a GM torsion bar tool apply pressure to torsion key
5. Remove adjuster bolt retaining plate
6. Slowly release the tension on the torsion bar tool
7. With tool removed slide torsion bar forward
8. The factory torsion bar key can now be removed
9. Install new torsion bar key by reversing the removal procedure
10. Insert adjuster bolt about halfway as a good starting point
11. Set truck back down and do a quick test drive
12. Check height of truck and adjust accordingly.
13. Have truck aligned
14.  

Shock Extension Bracket Installation

1. Lift the front of the truck and support the frame with jack stands
2. Remove upper shock mounting nut
3. Remove lower shock mounting bolt
4. Remove the shock from the vehicle
5. Remove two bolts that attach lower shock mount to lower control arm and discard lower shock mount, retain hardware
6. Install CCM Offroad shock mount with the shock mounting hole in the highest position, install factory bolts and torque to 45 ft lbs.
7. Reverse the shock removal procedure
8. Repeat on the other side.